Pitot/Static and cables to steering bar

02/24/2013

Tail Wheel

Went over to Ace this morning and got some clear hose and aluminum tube for the pitot/static system. Made the pitot tube by putting a couple rudder cables inside the tube before bending it carefully 90 degrees. Attached the steering bar to the lower rudder cables. Pulled out some 1/16" plywood to finish the cabaine and the elevator trim tab support. Tried some different chain connector to the tail because the screw on type that I wanted wasn't in stock. It didn't fit, though, so I'll need to go back tomorrow and get the correct one that I need to fit.